How To Repair Samsung Galaxy S5 Camera Lens

Introduction

To supercede the 16 megapixel rear-camera, follow the steps to remove all previous components required. Take full precaution when operating tools such as heat guns, equally they can cause potential health hazards.

Insert your fingernail or plastic opening tool into the divot at the top of the rear-facing camera.

Insert your fingernail or plastic opening tool into the divot at the meridian of the rear-facing camera.
Gently pry and twist the flexible rear cover off the dorsum of the phone.

Insert a fingernail or plastic opening tool into the recess in the bottom right corner of the battery and lift upward.

Insert a fingernail or plastic opening tool into the recess in the bottom correct corner of the battery and lift upward.
Remove the battery away from the telephone.

Employ your fingers to remove the SIM card

Make sure the battery, the SIM bill of fare, and the MicroSD card have been removed. If these components are not removed, they may get damaged when the oestrus is applied.
In this step you'll exist using a heat gun. The oestrus gun operates at high temperatures, and it may harm you or the device if not used appropriately. Please follow the heat gun rubber procedures indicated in information technology'southward manual to prevent any harm.
Use a rut gun at an estimate distance of 2-3 inches from the phone to apply heat to the phone and loosen upwardly the adhesive in the display.

Starting from the upper left corner, insert a guitar selection in betwixt the brandish and the phone instance.

Utilize the selection to pry the display past sliding the pick in the direction shown.
Make certain you pry the display around the edge of the telephone. At the lesser of the screen in that location is a sparse metallic strip that connects the display to the motherboard, and it can be easily damaged.
If any resistance is encountered, stop prying and reapply heat to proceed prying.

Apply the pick to pry the sides and lower office of the display by sliding the pick through the telephone.
If whatever resistance is encountered, cease prying and reapply heat to keep prying.

Using the guitar pick, lift the screen slightly.
You can remove the abode button if desired.

Slightly elevator, but practise not remove, the upper end of display assembly.
Do non remove the front console entirely. Information technology is still attached by a connector.
If y'all are reusing the dwelling button flex cable, be careful not to sever the cable from the home button. Adhesive can cause the cablevision to rip apart from the home button. While the home button volition yet work, the fingerprint scanner volition not.

Use the sharp tip of a guitar choice to lift the front panel assembly cable connector directly upwardly off its socket on the motherboard.
Safely remove the front panel assembly from phone.